Cisco 2100 Series Configuration Manual page 172

Configuring Cisco Discovery Protocol
This page shows the following information:
The name of each access point
•
The IP address of each access point
•
The name of each CDP neighbor
•
The IP address of each CDP neighbor
•
The port used by each CDP neighbor
•
The CDP version being advertised (v1 or v2)
•
To see detailed information about an access point's CDP neighbors, click the name of the desired access
Step 5
point. The CDP > AP Neighbors > Detail page appears (see
Figure 4-34
This page shows the following information:
• The name of the access point
The MAC address of the access point's radio
•
The IP address of the access point
•
The interface on which the CDP packets were received
•
The name of the CDP neighbor
•
The IP address of the CDP neighbor
•
The port used by the CDP neighbor
•
The CDP version being advertised (v1 or v2)
•
The time left (in seconds) before the CDP neighbor entry expires
•
The functional capability of the CDP neighbor, defined as follows: R - Router, T - Trans Bridge,
•
B - Source Route Bridge, S - Switch, H - Host, I - IGMP, r - Repeater, or M - Remotely Managed
Device
The hardware platform of the CDP neighbor device
•
The software running on the CDP neighbor
•
To see CDP traffic information, click Traffic Metrics. The CDP > Traffic Metrics page appears (see
Step 6
Figure
Cisco Wireless LAN Controller Configuration Guide
4-76
CDP > AP Neighbors > Detail Page
4-35).
Chapter 4 Configuring Controller SettingsWireless Device Access
Figure 4-34).
OL-17037-01