Cisco 2100 Series Configuration Manual page 667

Chapter 13 Configuring Hybrid REAPWireless Device Access
Perform one of the following:
Step 9
To choose an access point that is connected to this controller, check the Select APs from Current
•
Controller check box and choose the name of the access point from the AP Name drop-down box.
Note
• To choose an access point that is connected to a different controller, leave the Select APs from
Current Controller check box unchecked and enter its MAC address in the Ethernet MAC field.
Note
Click Add to add the access point to this hybrid-REAP group. The access point's MAC address, name,
Step 10
and status appear at the bottom of the page.
Note
Click Apply to commit your changes.
Step 11
Repeat
Step 12
If you want to enable local authentication for a hybrid-REAP group, follow these steps:
Step 13
Make sure that the Primary RADIUS Server and Secondary RADIUS Server parameters are set to
a.
None.
Check the Enable AP Local Authentication check box to enable local authentication for this
b.
hybrid-REAP group. The default value is unchecked.
Click Apply to commit your changes.
c.
Click the Local Authentication tab to open the HREAP Groups > Edit (Local Authentication >
d.
Local Users) page (see
OL-17037-01
If you choose an access point on this controller, the MAC address of the access point is
automatically entered in the Ethernet MAC field to prevent any mismatches from occurring.
If the hybrid-REAP access points within a group are connected to different controllers, all
of the controllers must belong to the same mobility group.
If you want to delete an access point, hover your cursor over the blue drop-down arrow for that
access point and choose Remove.
Step 9 through Step 11 if you want to add more access points to this hybrid-REAP group.
Figure 13-13).
Cisco Wireless LAN Controller Configuration Guide
Configuring Hybrid-REAP Groups
13-19