Using The Gui To Configure An Rf Group; Using The Cli To Configure Rf Groups - Cisco 2100 Series Configuration Manual

Chapter 11 Configuring Radio Resource ManagementWireless Device Access

Using the GUI to Configure an RF Group

Follow these steps to create an RF group using the GUI.
Click Controller > General to open the General page (see
Step 1
Figure 11-1
Enter a name for the RF group in the RF-Network Name field. The name can contain up to 19 ASCII
Step 2
characters.
Click Apply to commit your changes.
Step 3
Click Save Configuration to save your changes.
Step 4
Repeat this procedure for each controller that you want to include in the RF group.
Step 5

Using the CLI to Configure RF Groups

Follow these steps to configure an RF group using the CLI.
Step 1 Enter config network rf-network-name name to create an RF group.
Note
Enter show network to view the RF group.
Step 2
OL-17037-01
General Page
Enter up to 19 ASCII characters for the group name.
Figure 11-1).
Cisco Wireless LAN Controller Configuration Guide
Configuring an RF Group
11-7