Cisco 2100 Series Configuration Manual page 447

Chapter 7 Controlling Lightweight Access Points
Figure 7-27
This page lists all of the clients that are associated to the controller's access points. It provides the
following information for each client:
The MAC address of the client
•
The name of the access point to which the client is associated
•
The name of the WLAN used by the client
•
The type of client (802.11a, 802.11b, 802.11g, or 802.11n)
•
Note
The status of the client connection
•
The authorization status of the client
•
The port number of the access point to which the client is associated
•
An indication of whether the client is a WGB
•
Note
Note
To create a filter to display only clients that meet certain criteria (such as MAC address, status, or radio
Step 2
type), follow these steps:
Click Change Filter to open the Search Clients page (see
a.
OL-17037-01
Clients Page
If the 802.11n client associates to an 802.11a radio that has 802.11n enabled, then the client
type shows as 802.11n(5). If the 802.11n client associates to an 802.11b/g radio with
802.11n enabled, then the client type shows as 802.11n (2.4).
Refer to the "Cisco Workgroup Bridges" section on page 7-34
WGB status.
If you want to remove or disable a client, hover your cursor over the blue drop-down arrow for
that client and choose Remove or Disable, respectively. If you want to test the connection
between the client and the access point, hover your cursor over the blue drop-down arrow for
that client and choose Link Test.
for more information on the
Figure 7-28).
Cisco Wireless LAN Controller Configuration Guide
Viewing Clients
7-75