Configuring The Supervisor 720 To Support The Wism - Cisco 2100 Series Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
8.
9.
10.

Configuring the Supervisor 720 to Support the WiSM

When you install a WiSM in a Cisco Catalyst 6500 switch or a Cisco 7600 series router, you must
configure the Supervisor 720 to support the WiSM. When the supervisor detects the WiSM, the
supervisor creates ten Gigabit Ethernet interfaces, ranging from Gigslot/1 to Gigslot/8. For example, if
the WiSM is in slot 9, the supervisor creates interfaces Gig9/1 through Gig9/8. The first eight Gigabit
Ethernet interfaces must be organized into two Etherchannel bundles of four interfaces each. The
remaining two Gigabit Ethernet interfaces are used as service-port interfaces, one for each controller on
the WiSM. You must manually create VLANs to communicate with the ports on the WiSM.
Note The WiSM is supported on Cisco 7600 series routers running only Cisco IOS Release 12.2(18)SXF5.
OL-17037-01
Loc Subscr Req: 0
Loc Notif: 0
Loc Unsubscr Req: 0
IDS Get Req: 0
IDS Notif: 0
IDS Set Req: 0
To clear the NMSP statistics, enter this command:
clear nmsp statistics
To view all mobility services active on the controller, enter this command:
show services mobility summary
Information similar to the following appears:
Mobility Services Subscribed:
Server IP Applications
--------- -------------
172.19.35.218 Client Tracking, Tag Tracking, Rogue Tracking,
Handover Client Tracking, FMC, AP Monitor, IDS
To view detailed mobility services information for all connections or for a specific connection, enter
this command:
show services mobility detail {all | IP_address}
Information similar to the following appears for the show services mobility detail all command:
Mobility Services Subscribed by 172.19.35.218 -
Application
-----------
Client Tracking
Tag Tracking
Rogue Tracking
Handover Client Tracking
FMC
AP Monitor
IDS Services
Configuring the Supervisor 720 to Support the WiSM
Loc Subscr Rsp:
Loc Unsubscr Rsp:
IDS Get Resp:
IDS Set Resp:
Services
--------
RSSI, Info, Statistics
RSSI, Statistics
RSSI, Info
RSSI, Info,
Handover
AP Status
WIPS
Cisco Wireless LAN Controller Configuration Guide
0
0
0
0
4-89