Using The Gui To Configure Access Control Lists - Cisco 2100 Series Configuration Manual

Chapter 5 Configuring Security Solutions
ACLs in your network might need to be modified if CAPWAP uses different ports than LWAPP.
Note
You can configure and apply ACLs through either the GUI or the CLI.

Using the GUI to Configure Access Control Lists

Follow these steps to configure ACLs using the controller GUI.
Click Security > Access Control Lists > Access Control Lists to open the Access Control Lists page
Step 1
(see
Figure 5-29
This page lists all of the ACLs that have been configured for this controller.
Note
If you want to see if packets are hitting any of the ACLs configured on your controller, check the Enable
Step 2
Counters check box and click Apply. Otherwise, leave the check box unchecked, which is the default
value. This feature is useful when troubleshooting your system.
Note
Note
To add a new ACL, click New. The Access Control Lists > New page appears (see
Step 3
OL-17037-01
Figure 5-29).
Access Control Lists Page
If you want to delete an existing ACL, hover your cursor over the blue drop-down arrow for that
ACL and choose Remove.
If you want to clear the counters for an ACL, hover your cursor over the blue drop-down arrow
for that ACL and choose Clear Counters.
ACL counters are available only on the following controllers: 4400 series, Cisco WiSM, and
Catalyst 3750G Integrated Wireless LAN Controller Switch.
Configuring and Applying Access Control Lists
Cisco Wireless LAN Controller Configuration Guide
Figure 5-30).
5-55