Cisco 2100 Series Configuration Manual page 417

Chapter 7 Controlling Lightweight Access Points
To configure the access point heartbeat timer, enter this command:
Step 7
config advanced timers ap-heartbeat-timeout interval
where interval is a value between 1 and 30 seconds (inclusive). This value should be at least three times
larger than the fast heartbeat timer. The default value is 30 seconds.
To configure the access point primary discovery request timer, enter this command:
Step 8
config advanced timers ap-primary-discovery-timeout interval
where interval is a value between 30 and 3600 seconds. The default value is 120 seconds.
To configure the access point discovery timer, enter this command:
Step 9
config advanced timers ap-discovery-timeout interval
where interval is a value between 1 and 10 seconds (inclusive). The default value is 10 seconds.
To configure the 802.11 authentication response timer, enter this command:
Step 10
config advanced timers auth-timeout interval
where interval is a value between 10 and 600 seconds (inclusive). The default value is 10 seconds.
To save your changes, enter this command:
Step 11
save config
Step 12 To view an access point's configuration, enter these commands:
• show ap config general Cisco_AP
• show advanced backup-controller
show advanced timers
•
Information similar to the following appears for the show ap config general Cisco_AP command:
Cisco AP Identifier.............................. 1
Cisco AP Name.................................... AP5
Country code..................................... US
Regulatory Domain allowed by Country............. 802.11bg:-AB
AP Country code.................................. US
AP Regulatory Domain............................. 802.11bg:-A
Switch Port Number .............................. 1
MAC Address...................................... 00:13:80:60:48:3e
IP Address Configuration......................... DHCP
IP Address....................................... 1.100.163.133
...
Primary Cisco Switch Name........................ 1-4404
Primary Cisco Switch IP Address.................. 2.2.2.2
Secondary Cisco Switch Name...................... 1-4404
Secondary Cisco Switch IP Address................ 2.2.2.2
Tertiary Cisco Switch Name....................... 2-4404
Tertiary Cisco Switch IP Address................. 1.1.1.4
...
Information similar to the following appears for the show advanced backup-controller command:
AP primary Backup Controller .................... controller1 10.10.10.10
AP secondary Backup Controller ............... 0.0.0.0
OL-17037-01
Configuring Backup Controllers
- United States
802.11a:-AB
- United States
802.11a:-N
Cisco Wireless LAN Controller Configuration Guide
7-45