Cisco 2100 Series Configuration Manual page 124

Changing the Default Values for SNMP v3 Users
Figure 4-7
Step 2 If "default" appears in the User Name column, hover your cursor over the blue drop-down arrow for the
desired user and choose Remove to delete this SNMP v3 user.
Click New to add a new SNMP v3 user. The SNMP V3 Users > New page appears (see
Step 3
Figure 4-8
In the User Profile Name field, enter a unique name. Do not enter "default."
Step 4
Choose Read Only or Read Write from the Access Mode drop-down box to specify the access level for
Step 5
this user. The default value is Read Only.
From the Authentication Protocol drop-down box, choose the desired authentication method: None,
Step 6
HMAC-MD5 (Hashed Message Authentication Coding-Message Digest 5), or HMAC-SHA (Hashed
Message Authentication Coding-Secure Hashing Algorithm). The default value is HMAC-SHA.
Step 7 In the Auth Password and Confirm Auth Password fields, enter the shared secret key to be used for
authentication. You must enter at least 12 characters.
Step 8 From the Privacy Protocol drop-down box, choose the desired encryption method: None, CBC-DES
(Cipher Block Chaining-Digital Encryption Standard), or CFB-AES-128 (Cipher Feedback
Mode-Advanced Encryption Standard-128). The default value is CFB-AES-128.
Note
In the Priv Password and Confirm Priv Password fields, enter the shared secret key to be used for
Step 9
encryption. You must enter at least 12 characters.
Cisco Wireless LAN Controller Configuration Guide
4-28
SNMP V3 Users Page
SNMP V3 Users > New Page
In order to configure CBC-DES or CFB-AES-128 encryption, you must have selected either
HMAC-MD5 or HMAC-SHA as the authentication protocol in
Chapter 4 Configuring Controller SettingsWireless Device Access
Step
Figure 4-8).
6.
OL-17037-01