Downloading Configuration Files - Cisco 2100 Series Configuration Manual

Chapter 9 Managing Controller Software and Configurations
To specify the name of the configuration file to be uploaded, enter this command:
Step 6
transfer upload filename filename
If you are using an FTP server, enter these commands to specify the username and password used to log
Step 7
into the FTP server and the port number through which the upload occurs:
•
•
•
To initiate the upload process, enter this command:
Step 8
transfer upload start
When prompted to confirm the current settings, answer y. This example shows the upload command
Step 9
output:
Mode............................................. TFTP
TFTP Server IP................................... 10.10.10.4
TFTP Path........................................ Config/
TFTP Filename.................................... AS_4402_4_2_55_8_Config.xml
Data Type........................................ Config File
Encryption....................................... Disabled
**************************************************
***
**************************************************
Are you sure you want to start? (y/N) y
File transfer operation completed successfully.
If the upload fails, repeat this procedure and try again.

Downloading Configuration Files

You can download configuration files using either the GUI or the CLI.
Using the GUI to Download Configuration Files
Using the controller GUI, follow these steps to download a configuration file to the controller.
Click Commands > Download File to open the Download File to Controller page (see
Step 1
OL-17037-01
transfer upload username username
transfer upload password password
transfer upload port port
The default value for the port parameter is 21.
Note
WARNING: Config File Encryption Disabled
Transferring Files to and from a Controller
***
Cisco Wireless LAN Controller Configuration Guide
Figure 9-6).
9-23