Using The Gui To Configure Video Parameters - Cisco 2100 Series Configuration Manual

Configuring Voice and Video Parameters

Using the GUI to Configure Video Parameters

Follow these steps to configure video parameters using the GUI.
Make sure that the WLAN is configured for WMM and the Gold QoS level.
Step 1
Disable all WLANs with WMM enabled and click Apply.
Step 2
To disable the radio network, click Wireless and then Network under 802.11a/n or 802.11b/g/n, uncheck
Step 3
the 802.11a (or 802.11b/g) Network Status check box, and click Apply.
Click Video under 802.11a/n or 802.11b/g/n. The 802.11a (or 802.11b) > Video Parameters page appears
Step 4
(see
Figure 4-18
To enable video CAC for this radio band, check the Admission Control (ACM) check box. The default
Step 5
value is disabled.
Step 6 In the Max RF Bandwidth field, enter the percentage of the maximum bandwidth allocated to clients for
video applications on this radio band. Once the client reaches the value specified, the access point rejects
new requests on this radio band.
Range: 0 to 100% (However, the maximum RF bandwidth cannot exceed 100% for voice + video.)
Default: 0%
Note
Step 7 In the Reserved Roaming Bandwidth field, enter the percentage of maximum allocated bandwidth
reserved for roaming video clients. The controller reserves this much bandwidth from the maximum
allocated bandwidth for roaming video clients.
Range: 0 to 25%
Default: 0%
Click Apply to commit your changes.
Step 8
Re-enable all WMM WLANs and click Apply.
Step 9
Step 10 To re-enable the radio network, click Network under 802.11a/n or 802.11b/g/n, check the 802.11a (or
802.11b/g) Network Status check box, and click Apply.
Cisco Wireless LAN Controller Configuration Guide
4-56
Figure 4-17).
802.11a > Video Parameters Page
If this parameter is set to zero (0), the controller assumes that the operator does not want to do
any bandwidth allocation and, therefore, allows all bandwidth requests.
Chapter 4 Configuring Controller SettingsWireless Device Access
OL-17037-01