Cisco 2100 Series Configuration Manual page 162

Configuring Voice and Video Parameters
To see the TSM statistics for a particular access point and a particular client associated to this access
5.
point, enter this command:
show ap stats {802.11a | 802.11b} ap_name tsm [client_mac | all]
The optional all command shows all clients associated to this access point. Information similar to
the following appears:
AP Interface Mac:
Client Interface Mac:
Measurement Duration:
Note
To enable or disable debugging for call admission control (CAC) messages, events, or packets, enter
6.
this command:
debug cac {all | event | packet}{enable | disable}
where all configures debugging for all CAC messages, event configures debugging for all CAC
events, and packet configures debugging for all CAC packets.
Cisco Wireless LAN Controller Configuration Guide
4-66
Timestamp
UpLink Stats
================
Average Delay (5sec intervals)............................35
Delay less than 10 ms.....................................20
Delay bet 10 - 20 ms......................................20
Delay bet 20 - 40 ms......................................20
Delay greater than 40 ms..................................20
Total packet Count.........................................80
Total packet lost count (5sec).............................10
Maximum Lost Packet count(5sec)............................5
Average Lost Packet count(5secs)...........................2
DownLink Stats
================
Average Delay (5sec intervals)............................35
Delay less than 10 ms.....................................20
Delay bet 10 - 20 ms......................................20
Delay bet 20 - 40 ms......................................20
Delay greater than 40 ms..................................20
Total packet Count.........................................80
Total packet lost count (5sec).............................10
Maximum Lost Packet count(5sec)............................5
Average Lost Packet count(5secs)...........................2
The statistics are shown in 90-second intervals. The timestamp field shows the specific
interval when the statistics were collected.
Chapter 4 Configuring Controller SettingsWireless Device Access
00:0b:85:01:02:03
00:01:02:03:04:05
90 seconds
1st Jan 2006, 06:35:80
OL-17037-01