Using The Cli To Configure The Controller For Hybrid Reap; Configuring An Access Point For Hybrid Reap; Using The Gui To Configure An Access Point For Hybrid Reap - Cisco 2100 Series Configuration Manual

Chapter 13 Configuring Hybrid REAPWireless Device Access

Using the CLI to Configure the Controller for Hybrid REAP

Use these commands to configure the controller for hybrid REAP:
•
•
Go to the
Note
access points for hybrid REAP.
Use these commands to obtain hybrid-REAP information:
•
•
•
Use these commands to obtain debug information:
•
•
•
•
•

Configuring an Access Point for Hybrid REAP

This section provides instructions for configuring an access point for hybrid REAP using either the
controller GUI or CLI.

Using the GUI to Configure an Access Point for Hybrid REAP

Follow these steps to configure an access point for hybrid REAP using the controller GUI.
Make sure that the access point has been physically added to your network.
Step 1
OL-17037-01
config wlan h-reap local-switching wlan_id enable—Configures the WLAN for local switching.
When you enable hybrid-REAP local switching, the controller waits to learn the client IP
Note
address by default. However, if the client is configured with Fortress Layer 2 encryption, the
controller cannot learn the client IP address, and the controller periodically drops the client.
Use this command to disable the client IP address learning feature so that the controller
maintains the client connection without waiting to learn the client IP address: config wlan
h-reap learn-ipaddr wlan_id disable. The ability to disable this feature is supported only
with hybrid-REAP local switching; it is not supported with hybrid-REAP central switching.
If you later want to re-enable this feature, enter this command: config wlan h-reap
learn-ipaddr wlan_id enable.
config wlan h-reap local-switching wlan_id disable—Configures the WLAN for central
switching. This is the default value.
"Configuring an Access Point for Hybrid REAP" section on page 13-11
show ap config general Cisco_AP—Shows VLAN configurations.
show wlan wlan_id—Shows whether the WLAN is locally or centrally switched.
show client detail client_mac—Shows whether the client is locally or centrally switched.
debug hreap aaa {event | error} {enable | disable}—Enables or disables debugging of
hybrid-REAP backup RADIUS server events or errors.
debug hreap cckm {enable | disable}—Enables or disables debugging of hybrid-REAP CCKM.
debug hreap group {enable | disable}—Enables or disables debugging of hybrid-REAP groups.
debug pem state {enable | disable}—Enables or disables debugging of the policy manager state
machine.
debug pem events {enable | disable}—Enables or disables debugging of policy manager events.
Cisco Wireless LAN Controller Configuration Guide
Configuring Hybrid REAP
to configure up to six
13-11