Chapter 6
Configuring WLANsWireless Device Access
Using the GUI to Configure QBSS
Using the controller GUI, follow these steps to configure QBSS.
Step 1
Click WLANs to open the WLANs page.
Click the ID number of the WLAN for which you want to configure WMM mode.
Step 2
When the WLANs > Edit page appears, click the QoS tab to open the WLANs > Edit (Qos) page (see
Step 3
Figure
Figure 6-14
Step 4
From the WMM Policy drop-down box, choose one of the following options, depending on whether you
want to enable WMM mode for 7921 phones and other devices that meet the WMM standard:
•
•
•
Step 5
Check the 7920 AP CAC check box if you want to enable 7920 support mode for phones that require
access point-controlled CAC. The default value is unchecked.
Step 6
Check the 7920 Client CAC check box if you want to enable 7920 support mode for phones that require
client-controlled CAC. The default value is unchecked.
Note
Click Apply to commit your changes.
Step 7
Step 8
Click Save Configuration to save your changes.
OL-17037-01
6-14).
WLANs > Edit (QoS) Page
Disabled—Disables WMM on the WLAN. This is the default value.
Allowed—Allows client devices to use WMM on the WLAN.
Required—Requires client devices to use WMM. Devices that do not support WMM cannot join
the WLAN.
You cannot enable both WMM mode and client-controlled CAC mode on the same WLAN.
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
6-35