Using The Cli To Configure Roaming And Real-Time Diagnostics - Cisco 2100 Series Configuration Manual

Appendix D Troubleshooting
Radio Type....................................... ERP(802.11g)
Rx Sensitivity .................................. Rate:6.0 Mbps, MinRssi:-95, MaxRssi:-30
Rx Sensitivity .................................. Rate:9.0 Mbps, MinRssi:-95, MaxRssi:-30
Rx Sensitivity .................................. Rate:12.0 Mbps, MinRssi:-95, MaxRssi:-30
Rx Sensitivity .................................. Rate:18.0 Mbps, MinRssi:-95, MaxRssi:-30
To see the client's capability information, enter this command:
Step 9
show client ccx client-capability client_mac_address
Note
Information similar to the following appears:
Service Capability............................... Voice, Streaming(uni-directional) Video,
Interactive(bi-directional) Video
Radio Type....................................... DSSS OFDM(802.11a) HRDSSS(802.11b)
ERP(802.11g)
Radio Type....................................... DSSS
Radio Channels................................. 1 2 3 4 5 6 7 8 9 10 11
Tx Power Mode.................................. Automatic
Rate List(MB).................................. 1.0 2.0
Radio Type....................................... HRDSSS(802.11b)
Radio Channels................................. 1 2 3 4 5 6 7 8 9 10 11
Tx Power Mode.................................. Automatic
Rate List(MB).................................. 5.5 11.0
Radio Type....................................... ERP(802.11g)
Radio Channels................................. 1 2 3 4 5 6 7 8 9 10 11
Tx Power Mode.................................. Automatic
Rate List(MB).................................. 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0
Radio Type....................................... OFDM(802.11a)
Radio Channels................................. 36 40 44 48 52 56 60 64 100 104 108 112
116 120 124 128 132 136 140 149 153 157 161 165
Tx Power Mode.................................. Automatic
Rate List(MB).................................. 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0

Using the CLI to Configure Roaming and Real-Time Diagnostics

Using the controller CLI, follow these steps to configure roaming and real-time diagnostics.
To send a log request, enter this command:
Step 1
config client ccx log-request log_type client_mac_address
where log_type is roam, rsna, or syslog.
To view a log response, enter this command:
Step 2
show client ccx log-response log_type client_mac_address
where log_type is roam, rsna, or syslog.
OL-17037-01
This command displays the client's available capabilities, not current settings for the
capabilities.
Troubleshooting CCXv5 Client Devices
Cisco Wireless LAN Controller Configuration Guide
D-31