Cisco 2100 Series Configuration Manual page 482

Adding Mesh Access Points to the Mesh Network
Figure 8-16
Click Apply to commit your changes.
Step 9
At the Wireless > Mesh page, select the appropriate backhaul rate from the bridge data rate drop-down
Step 10
menu. The default value is 24 Mbps for the 802.11a backhaul interface.
Click Apply to commit your changes.
Step 11
Click Save Configuration to save your changes.
Step 12
Table 8-5
Table 8-5
Parameter
Bridge type
Backhaul Interface
Ethernet Link Status
Heater Status
Internal Temperature
Cisco Wireless LAN Controller Configuration Guide
8-30
All APs > AP > VLAN Mappings Page
describes display-only parameters on the mesh page.
Display Parameters for Access Points
Chapter 8 Controlling Mesh Access Points
Description
Displays either outdoor (152x access points) or
indoor (1130 or 1240 access points)
Displays the radio band that this MAP uses to
transfer data to other MAPs. The only possible
value is 802.11a.
Displays the up or down status of the Ethernet link
of the AP152x. The Up or Down (Dn) status of the
four Ethernet ports is reported in the following
format: port0:port1:port2:port3. For example,
UpDnDnDn indicates that port0 is Up and ports 1,
2, and 3 are Down (Dn).
If NA displays in the status string, then the
Note
port has no wired connection to that port.
Displays status of either ON or OFF.
Displays the internal temperature of the 1522 and
1524.
OL-17037-01