Configuring Mobility Groups; Prerequisites - Cisco 2100 Series Configuration Manual

Chapter 12 Configuring Mobility GroupsWireless Device Access
Figure 12-7
Anchor controller
Mobility group

Configuring Mobility Groups

This section provides instructions for configuring controller mobility groups through either the GUI or
the CLI.
Note You can also configure mobility groups using the Cisco Wireless Control System (WCS). Refer to the
Cisco Wireless Control System Configuration Guide for instructions.

Prerequisites

Before you add controllers to a mobility group, you must verify that the following requirements have
been met for all controllers that are to be included in the group:
•
•
OL-17037-01
Mobility Group Configuration with Two NAT Devices
12.x.x.2
NAT
13.x.x.2
(9.x.x.1)
13.x.x.2
IP connectivity must exist between the management interfaces of all controllers.
You can verify IP connectivity by pinging the controllers.
Note
All controllers must be configured with the same mobility group name.
The mobility group name is generally set at deployment time through the Startup Wizard.
Note
However, you can change it if necessary through the Default Mobility Domain Name field
on the Controller > General page. The mobility group name is case sensitive.
10.x.x.2
NAT
11.x.x.2
Internet backbone
Cisco Wireless LAN Controller Configuration Guide
Configuring Mobility Groups
Foreign controller
(10.x.x.1)
Mobility group
(10.x.x.2)
12-9