Using The Gui To View Cisco Discovery Protocol Information - Cisco 2100 Series Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
Figure 4-29
•
Click Save Configuration to save your changes.
Step 9

Using the GUI to View Cisco Discovery Protocol Information

Follow these steps to view CDP information using the controller GUI.
To see a list of all CDP neighbors on all interfaces, click Monitor > CDP > Interface Neighbors. The
Step 1
CDP > Interface Neighbors page appears (see
OL-17037-01
All APs > Details for (Advanced) Page
d. Check the Cisco Discovery Protocol check box to enable CDP on this access point or uncheck
it to disable this feature. The default value is enabled.
e. Click Apply to commit your changes.
To enable or disable CDP on all access points currently associated to the controller, follow these
steps:
Click Wireless > Access Points > Global Configuration to open the Global Configuration
a.
page.
Check the CDP State check box to enable CDP on all access points associated to the controller
b.
or uncheck it to disable CDP on all access points. The default value is checked.
Click Apply to commit your changes.
c.
Configuring Cisco Discovery Protocol
Figure 4-30).
Cisco Wireless LAN Controller Configuration Guide
4-73