Synchronizing The Controller And Location Appliance; Using The Cli To View Location Settings - Cisco 2100 Series Configuration Manual

Configuring and Viewing Location Settings
To view the NMSP configuration setting, enter this command:
Step 2
show nmsp notify-interval summary
Information similar to the following appears:
NMSP Notification Interval Summary
Client
RFID
Rogue AP
Rogue Client

Synchronizing the Controller and Location Appliance

For controller software release 4.2 or later, if a location appliance (release 3.1 or later) is installed on
your network, the time zone must be set on the controller to ensure proper synchronization between the
two systems. Also, Cisco highly recommends that the time be set for networks that do not have location
appliances. Refer to the
setting the time and date on the controller.
The time zone can be different for the controller and the location appliance, but the time zone delta must
Note
be configured accordingly, based on GMT.

Using the CLI to View Location Settings

The controller determines the location of client devices by gathering received signal strength indicator
(RSSI) measurements from access points all around the client of interest. The controller can obtain
location reports from up to 16 access points for both clients and RFID tags.
Use these commands to view location information using the controller CLI.
1.
Cisco Wireless LAN Controller Configuration Guide
4-86
Measurement interval: 2 sec
Measurement interval: 8 sec
Measurement interval: 2 sec
Measurement interval: 2 sec
"Managing the System Date and Time" section on page 4-10
To view the current location configuration values, enter this command:
show location summary
Information similar to the following appears:
Location Summary
Algorithm used:
Client
RSSI expiry timeout:
Half life:
Notify Threshold:
Calibrating Client
RSSI expiry timeout:
Half life:
Rogue AP
RSSI expiry timeout:
Half life:
Notify Threshold:
Chapter 4 Configuring Controller SettingsWireless Device Access
Average
5 sec
0 sec
0 db
5 sec
0 sec
5 sec
0 sec
0 db
for instructions on
OL-17037-01