Cisco 2100 Series Configuration Manual page 356

Configuring WLANs
Figure 6-21 AP Groups > Edit (WLANs) Page
From the WLAN SSID drop-down box, choose the SSID of the WLAN.
Step 10
From the Interface Name drop-down box, choose the interface to which you want to map the access point
Step 11
group. Choose the quarantine VLAN if you plan to enable network admission control (NAC) out-of-band
support.
Note
To enable NAC out-of-band support for this access point group, check the NAC State check box. To
Step 12
disable NAC out-of-band support, leave the check box unchecked, which is the default value. Refer to
the "Configuring NAC Out-of-Band Integration" section on page 6-55
Click Add to add this WLAN to the access point group. This WLAN appears in the list of WLANs that
Step 13
are assigned to this access point group.
Note
Step 14 Repeat
Step 15 Click the APs tab to assign access points to this access point group. The AP Groups > Edit (APs) page
lists the access points that are currently assigned to this group as well as any access points that are
available to be added to the group. If an access point is not currently assigned to a group, its group name
appears as "default-group" (see
Figure 6-22 AP Groups > Edit (APs) Page
Cisco Wireless LAN Controller Configuration Guide
6-46
The interface name in the default-group access point group matches the WLAN interface.
If you ever want to remove this WLAN from the access point group, hover your cursor over the
blue drop-down arrow for the WLAN and choose Remove.
Step 9 through Step 13 to add any additional WLANs to this access point group.
Figure
Chapter 6
6-22).
Configuring WLANsWireless Device Access
for more information on NAC.
OL-17037-01