Using The Cli To Configure Ids Signatures - Cisco 2100 Series Configuration Manual

Chapter 5 Configuring Security Solutions
•
•
To see more information for a particular attack, click the Detail link for that attack. The Signature Events
Step 3
Track Detail page appears (see
Figure 5-62
This page shows the following information:
•
•
•
•
•

Using the CLI to Configure IDS Signatures

Follow these steps to configure IDS signatures using the controller CLI.
If desired, create your own custom signature file.
Step 1
Make sure that you have a TFTP server available. See the guidelines for setting up a TFTP server in
Step 2
Step 2
Copy the custom signature file (*.sig) to the default directory on your TFTP server.
Step 3
To specify the download or upload mode, enter transfer {download | upload} mode tftp.
Step 4
To specify the type of file to be downloaded or uploaded, enter transfer {download | upload} datatype
Step 5
signature.
To specify the IP address of the TFTP server, enter transfer {download | upload} serverip
Step 6
tftp-server-ip-address.
Note
OL-17037-01
The number of access points on the channel on which the attack was detected
The day and time when the access point detected the attack
Signature Events Track Detail Page
The MAC address of the access point that detected the attack
The name of the access point that detected the attack
The type of radio (802.11a or 802.11b/g) used by the access point to detect the attack
The radio channel on which the attack was detected
The day and time when the access point reported the attack
of the "Using the GUI to Upload or Download IDS Signatures" section on page
Some TFTP servers require only a forward slash (/) as the TFTP server IP address, and the TFTP
server automatically determines the path to the correct directory.
Figure 5-62).
Cisco Wireless LAN Controller Configuration Guide
Configuring IDS
5-110.
5-115