Chapter 4
Configuring Controller SettingsWireless Device Access
This page shows the following information:
The controller port on which the CDP packets were received
•
The name of the CDP neighbor
•
The IP address of the CDP neighbor
•
The port used by the CDP neighbor for transmitting CDP packets
•
The CDP version being advertised (v1 or v2)
•
The time left (in seconds) before the CDP neighbor entry expires
•
The functional capability of the CDP neighbor, defined as follows: Router, Trans Bridge,
•
Source Route Bridge, Switch, Host, IGMP, Repeater, or Remotely Managed Device
The hardware platform of the CDP neighbor device
•
The software running on the CDP neighbor
•
To see a list of CDP neighbors for all access points connected to the controller, click AP Neighbors. The
Step 3
CDP AP Neighbors page appears (see
Figure 4-32
Step 4
To see a list of CDP neighbors for a specific access point, click the CDP Neighbors link for the desired
access point. The CDP > AP Neighbors page appears (see
Figure 4-33
OL-17037-01
Figure
CDP AP Neighbors Page
CDP > AP Neighbors Page
Configuring Cisco Discovery Protocol
4-32).
Figure
4-34).
Cisco Wireless LAN Controller Configuration Guide
4-75