Cisco 2100 Series Configuration Manual page 616

Configuring Pico Cell Mode
To see the receiver parameters that are set by the pico cell mode commands, enter this command:
2.
show advanced {802.11a | 802.11b} receiver
Information similar to the following appears:
802.11a Advanced Receiver Settings
Tx Pwr: Min,Max,Current Transmit Power for A..... -127,127,10
To see the noise and interference information, coverage information, client signal strengths and
3.
signal-to-noise ratios, and nearby access points, enter this command:
show ap auto-rf {802.11a | 802.11b} Cisco_AP
Information similar to the following appears:
Number Of Slots.................................. 2
AP Name.......................................... AP1242.47b2.31f6
MAC Address...................................... 00:16:47:b2:31:f6
Cisco Wireless LAN Controller Configuration Guide
11-46
RxStart : Signal Threshold..................... 30
RxStart : Signal Jump Threshold................ 5
RxStart : Preamble Power Threshold............. 30
RxRestart: Signal Jump Status................... Enabled
RxRestart: Signal Jump Threshold................ 10
TxStomp : Low RSSI Status...................... Disabled
TxStomp : Low RSSI Threshold................... 30
TxStomp : Wrong BSSID Status................... Disabled
TxStomp : Wrong BSSID Data Only Status......... Disabled
RxAbort : Raw Power Drop Status................ Disabled
RxAbort : Raw Power Drop Threshold............. 10
RxAbort : Low RSSI Status...................... Disabled
RxAbort : Low RSSI Threshold................... 30
RxAbort : Wrong BSSID Status................... Disabled
RxAbort : Wrong BSSID Data Only Status......... Disabled
--------------------------------------------....
pico-cell-V2 parameters in dbm units:
RxSensitivity: Min,Max,Current RxSense Thres.... -127,127,-65
CCA Threshold: Min,Max,Current Clear Channel.... -127,127,-65
--------------------------------------------....
Radio Type..................................... RADIO_TYPE_80211a
Noise Information
Noise Profile................................ PASSED
Interference Information
Interference Profile......................... PASSED
Load Information
Load Profile................................. PASSED
Receive Utilization.......................... 0 %
Transmit Utilization......................... 0 %
Channel Utilization.......................... 0 %
Attached Clients............................. 0 clients
Coverage Information
Coverage Profile............................. PASSED
Failed Clients............................... 0 clients
Client Signal Strengths
RSSI -100 dbm................................ 0 clients
RSSI -92 dbm................................ 0 clients
RSSI -84 dbm................................ 0 clients
RSSI -76 dbm................................ 0 clients
RSSI -68 dbm................................ 0 clients
RSSI -60 dbm................................ 0 clients
RSSI -52 dbm................................ 0 clients
Chapter 11 Configuring Radio Resource ManagementWireless Device Access
OL-17037-01