Using The Cli To Optimize Rfid Tracking On Access Points - Cisco 2100 Series Configuration Manual

Chapter 7 Controlling Lightweight Access Points
Click Apply to commit your changes.
Step 12
Click Save Configuration to save your changes.
Step 13
To re-enable the access point radio, choose Enable from the Admin Status drop-down box and click Apply.
Step 14
Click Save Configuration to save your changes.
Step 15

Using the CLI to Optimize RFID Tracking on Access Points

Using the controller CLI, follow these steps to optimize RFID tracking.
Step 1 To configure an access point for monitor mode, enter this command:
config ap mode monitor Cisco_AP
Step 2 When warned that the access point will be rebooted and asked if you want to continue, enter Y.
To save your changes, enter this command:
Step 3
save config
To disable the access point radio, enter this command:
Step 4
config 802.11b disable Cisco_AP
To configure the access point to scan only the DCA channels supported by its country of operation, enter
Step 5
this command:
config ap monitor-mode tracking-opt Cisco_AP
Note
Note
After you have entered the command in
Step 6
802.11b channels to be scanned by the access point:
config ap monitor-mode 802.11b fast-channel Cisco_AP channel1 channel2 channel3 channel4
Note
To re-enable the access point radio, enter this command:
Step 7
config 802.11b enable Cisco_AP
To save your changes, enter this command:
Step 8
save config
OL-17037-01
To specify the exact channels to be scanned, enter this command and the command in
To disable tracking optimization for this access point, enter this command: config ap
monitor-mode no-optimization Cisco_AP.
In the United States, you can assign any value between 1 and 11 (inclusive) to the channel
variable. Other countries support additional channels. You must assign at least one channel.
Step 5, you can enter this command to choose up to four specific
Cisco Wireless LAN Controller Configuration Guide
Optimizing RFID Tracking on Access Points
Step 6.
7-61