Using The Cli To Configure Pico Cell Mode - Cisco 2100 Series Configuration Manual

Configuring Pico Cell Mode
Note
Table 11-3
Parameter
Rx Sensitivity Threshold
CCA Sensitivity Threshold
Transmit Power
Note
Click Apply to commit your changes.
Step 5
Re-enable the 802.11a or 802.11b/g network. To do so, click Wireless > 802.11a/n (or 802.11b/g/n) >
Step 6
Network and check the 802.11a Network Status (or 802.11b/g Network Status) check box.
Click Save Configuration to save your changes.
Step 7
Note

Using the CLI to Configure Pico Cell Mode

Refer to the
Note
default values of the parameters used in the CLI commands.
Cisco Wireless LAN Controller Configuration Guide
11-44
The default values for these parameters should be appropriate for most applications. Therefore,
Cisco recommends that you use the default values.
Pico Cell Mode V2 Parameters
Description
Specifies the current, minimum, and maximum values (in dBm) for
the receiver sensitivity of the 802.11a or 802.11b/g radio. The current
value sets the receiver sensitivity on the local radio. The min and max
values are used only for inclusion in the Inter-Access Point Protocol
(IAPP) high-density reports.
Default: –65 dBm (Current), –127 dBm (Min), and 127 dBm (Max)
Specifies the clear channel assessment (CCA) sensitivity threshold on
all radios in the high-density cell. The current value programs the
802.11a or 802.11b/g receiver. The min and max values are for
advertisement in IAPP reports.
Default: –65 dBm (Current), –127 dBm (Min), and 127 dBm (Max)
Specifies the high-density transmit power used by both the access
point and client 802.11a or 802.11b/g radios.
Default: 10 dBm (Current), –127 dBm (Min), and 127 dBm (Max)
The min and max values in
the client. They are not used on the access point.
If you change the values of the pico cell mode parameters and later want to reset them to their
default values, click Reset to Defaults and then click Apply.
"Using the GUI to Configure Pico Cell Mode" section on page 11-42
Chapter 11 Configuring Radio Resource ManagementWireless Device Access
Figure 11-16 and Table 11-3 are used only to indicate the range to
for descriptions and
OL-17037-01