Cisco 2100 Series Configuration Manual page 610

Configuring CCX Radio Management Features
To see the status of radio measurement requests for a particular access point, enter this command:
3.
show ap ccx rm Cisco_AP status
Information similar to the following appears:
A Radio
B Radio
To see the status of radio measurement requests for a particular client, enter this command:
4.
show client ccx rm client_mac status
Information similar to the following appears:
Client Mac Address............................... 00:40:96:ae:53:b4
Beacon Request................................... Enabled
Channel Load Request............................. Disabled
Frame Request.................................... Disabled
Noise Histogram Request.......................... Disabled
Path Loss Request................................ Disabled
Interval......................................... 5
Iteration........................................ 3
To see radio measurement reports for a particular client, enter these commands:
5.
To see the clients configured for location calibration, enter this command:
6.
show client location-calibration summary
To see the RSSI reported for both antennas on each access point that heard the client, enter this
7.
command:
show client detail client_mac
Cisco Wireless LAN Controller Configuration Guide
11-40
Beacon Request................................. Enabled
Channel Load Request........................... Enabled
Frame Request.................................. Disabled
Noise Histogram Request........................ Disabled
Path Loss Request.............................. Disabled
Interval....................................... 60
Iteration...................................... 5
Beacon Request................................. Disabled
Channel Load Request........................... Enabled
Frame Request.................................. Disabled
Noise Histogram Request........................ Enabled
Path Loss Request.............................. Disabled
Interval....................................... 60
Iteration................................... 5
show client ccx rm client_mac report beacon—Shows the beacon report for the specified
•
client.
show client ccx rm client_mac report chan-load—Shows the channel-load report for the
•
specified client.
show client ccx rm client_mac report noise-hist—Shows the noise-histogram report for the
•
specified client.
show client ccx rm client_mac report frame—Shows the frame report for the specified client.
•
Chapter 11 Configuring Radio Resource ManagementWireless Device Access
OL-17037-01