Splash Page Web Redirect; Configuring The Radius Server - Cisco 2100 Series Configuration Manual

Configuring WLANs

Splash Page Web Redirect

If you enable splash page web redirect, the user is redirected to a particular web page after 802.1X
authentication has completed successfully. After the redirect, the user has full access to the network. You
can specify the redirect page on your RADIUS server. If the RADIUS server returns the Cisco AV-pair
"url-redirect," then the user is redirected to the specified URL upon opening a browser. The client is
considered fully authorized at this point and is allowed to pass traffic, even if the RADIUS server does
not return a "url-redirect."
Note The splash page web redirect feature is available only for WLANs that are configured for 802.1X or
WPA+WPA2 Layer 2 security.
After you configure the RADIUS server, you can then configure the splash page web redirect on the
controller using either the controller GUI or CLI.

Configuring the RADIUS Server

Follow these steps to configure your RADIUS server.
These instructions are specific to the CiscoSecure ACS; however, they should be similar to those for
Note
other RADIUS servers.
From the CiscoSecure ACS main menu, click Group Setup.
Step 1
Click Edit Settings.
Step 2
From the Jump To drop-down menu, choose RADIUS (Cisco IOS/PIX 6.0). The window shown in
Step 3
Figure 6-23
Cisco Wireless LAN Controller Configuration Guide
6-50
appears.
Chapter 6 Configuring WLANsWireless Device Access
OL-17037-01