Using The Gui To Assign A Qos Profile To A Wlan - Cisco 2100 Series Configuration Manual

Chapter 6 Configuring WLANsWireless Device Access
The WLAN QoS level defines a specific 802.11e user priority (UP) for over-the-air traffic. This UP is
used to derive the over-the-wire priorities for non-WMM traffic, and it also acts as the ceiling when
managing WMM traffic with various levels of priorities. The access point uses this QoS-profile-specific
UP in accordance with the values in
LAN.
Table 6-1
AVVID Traffic Type
Network control
Inter-network control
(CAPWAP control,
802.11 management)
Voice
Interactive video
Streaming video
Mission critical
Call signaling
Transactional
Network management
Bulk data
Best effort
Scavenger
You can assign a QoS profile to a WLAN using the controller GUI or CLI.

Using the GUI to Assign a QoS Profile to a WLAN

Using the controller GUI, follow these steps to assign a QoS profile to a WLAN.
If you have not already done so, configure one or more QoS profiles using the instructions in the
Step 1
the GUI to Configure QoS Profiles" section on page
Click WLANs to open the WLANs page.
Step 2
Click the ID number of the WLAN to which you want to assign a QoS profile.
Step 3
When the WLANs > Edit page appears, click the QoS tab.
Step 4
From the Quality of Service (QoS) drop-down box, choose one of the following:
Step 5
•
•
•
•
Note
OL-17037-01
Access Point QoS Translation Values
AVVID IP DSCP
56 (CS7)
48 (CS6)
46 (EF)
34 (AF41)
32 (CS4)
26 (AF31)
24 (CS3)
18 (AF21)
16 (CS2)
10 (AF11)
0 (BE)
8 (CS1)
Platinum (voice)
Gold (video)
Silver (best effort)
Bronze (background)
Silver (best effort) is the default value.
Table 6-1 to derive the IP DSCP value that is visible on the wired
QoS Profile
Platinum
Platinum
Platinum
Gold
Gold
Gold
Gold
Silver
Silver
Bronze
Silver
Bronze
4-45.
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
AVVID 802.1p IEEE 802.11e UP
7 7
6 7
5 6
4 5
4 5
3 4
3 4
2 3
2 3
1 2
0 0
0 1
"Using
6-31