Cisco 2100 Series Configuration Manual page 358

Configuring WLANs
To assign an access point to an access point group, enter this command:
Step 5
config ap group-name group_name Cisco_AP
Note
To save your changes, enter this command:
Step 6
save config
Using the CLI to View Access Point Groups
Use these CLI commands to view information about or to troubleshoot access point groups.
1.
2.
Cisco Wireless LAN Controller Configuration Guide
6-48
To remove an access point from an access point group, re-enter this command and assign the
access point to another group.
To see a list of all access point groups on the controller, enter this command:
show wlan apgroups
Information similar to the following appears:
Site Name........................................ AP2
Site Description................................. Access Point 2
WLAN ID Interface
------- -----------
1 management
2 management
3 management
4 management
9 management
10 management
11 management
12 management
13 management
14 management
15 management
16 management
18 management
AP Name Slots AP Model
------- ---- -------------- ----------------- ------- ---- ------- -------- ---------
AP1242 2 AP1242AG-A-K9 00:14:1c:ed:23:9a default
...
To see the BSSIDs for each WLAN assigned to an access point group, enter this command:
show ap wlan {802.11a | 802.11b} Cisco_AP
Information similar to the following appears:
Site Name........................................ AP3
Site Description................................. Access Point 3
WLAN ID Interface
------- ------------
10 management
Chapter 6
Network Admission Control
--------------------------
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Ethernet MAC Location Port Country Priority GroupName
BSSID
-------------------
00:14:1b:58:14:df
Configuring WLANsWireless Device Access
1 US 1 AP2
OL-17037-01