Using The Cli To Configure System And Message Logging - Cisco 2100 Series Configuration Manual

Wireless lan controller
Hide thumbs Also See for 2100 Series:
Table of Contents

Advertisement

Configuring System and Message Logging

Using the CLI to Configure System and Message Logging

Using the CLI, follow these steps to configure system and message logging.
To enable system logging and set the IP address of the syslog server to which to send the syslog
Step 1
messages, enter this command:
config logging syslog host server_IP_address
You can add up to three syslog servers to the controller.
Note
To set the severity level for filtering syslog messages to the syslog server, enter this command:
Step 2
config logging syslog level severity_level
where severity_level is one of the following:
Note
Note
Step 3
To set the facility for outgoing syslog messages to the syslog server, enter this command:
config logging syslog facility facility_code
where facility_code is one of the following:
Cisco Wireless LAN Controller Configuration Guide
D-10
To remove a syslog server from the controller, enter this command:
config logging syslog host server_IP_address delete
emergencies = Severity level 0
alerts = Severity level 1
critical = Severity level 2
errors = Severity level 3
warnings = Severity level 4
notifications = Severity level 5
informational = Severity level 6
debugging = Severity level 7
As an alternative, you can enter a number from 0 through 7 for the severity_level parameter.
If you set a syslog level, only those messages whose severity is equal to or less than that level
are sent to the syslog server. For example, if you set the syslog level to Warnings (severity level
4), only those messages whose severity is between 0 and 4 are sent to the syslog server.
authorization = Authorization system. Facility level = 4.
auth-private = Authorization system (private). Facility level = 10.
cron = Cron/at facility. Facility level = 9.
daemon = System daemons. Facility level = 3.
ftp = FTP daemon. Facility level = 11.
kern = Kernel. Facility level = 0.
local0 = Local use. Facility level = 16.
Appendix D
Troubleshooting
OL-17037-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4400 series

Table of Contents