Using The Cli To Create Wlans - Cisco 2100 Series Configuration Manual

Chapter 6 Configuring WLANsWireless Device Access
In the Profile Name field, enter up to 32 alphanumeric characters for the profile name to be assigned to
Step 4
this WLAN. The profile name must be unique.
Step 5 In the WLAN SSID field, enter up to 32 alphanumeric characters for the SSID to be assigned to this
WLAN.
Step 6 From the WLAN ID drop-down box, choose the ID number for this WLAN.
Step 7 Click Apply to commit your changes. The WLANs > Edit page appears (see
Note
Figure 6-3
Use the parameters on the General, Security, QoS, and Advanced tabs to configure this WLAN. Refer to
Step 8
the sections in the rest of this chapter for instructions on configuring specific features for WLANs.
On the General tab, check the Status check box to enable this WLAN. Be sure to leave it unchecked until
Step 9
you have finished making configuration changes to the WLAN.
Note
Click Apply to commit your changes.
Step 10
Click Save Configuration to save your changes.
Step 11

Using the CLI to Create WLANs

Use these commands to create WLANs using the CLI.
1.
OL-17037-01
You can also open the WLANs > Edit page from the WLANs page by clicking the ID number of
the WLAN that you want to edit.
WLANs > Edit Page
You can also enable or disable WLANs from the WLANs page by checking the check boxes to
the left of the WLANs that you want to enable or disable, choosing Enable Selected or Disable
Selected from the drop-down box, and clicking Go.
To view the list of existing WLANs and to see whether they are enabled or disabled, enter this
command:
show wlan summary
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
Figure 6-3).
6-5