Cisco 2100 Series Configuration Manual page 524

Wireless lan controller
Hide thumbs Also See for 2100 Series:
Table of Contents

Advertisement

Transferring Files to and from a Controller
Enter transfer download serverip server-ip-address.
Step 4
Enter transfer download path server-path-to-file.
Step 5
Enter transfer download filename filename.pem.
Step 6
If you are using a TFTP server, enter these commands:
Step 7
transfer download tftpMaxRetries retries
transfer download tftpPktTimeout timeout
Note
Step 8
If you are using an FTP server, enter these commands:
transfer download username username
transfer download password password
transfer download port port
Note
Enter transfer download start to view the updated settings; then answer y when prompted to confirm
Step 9
the current settings and start the download process. This example shows the download command output:
Mode........................................... TFTP
Data Type................................... Vendor CA Cert
TFTP Server IP.............................. 10.10.10.4
TFTP Packet Timeout............................ 6
TFTP Max Retries............................... 10
TFTP Path................................... /tftpboot/username/
TFTP Filename............................... filename.pem
This may take some time.
Are you sure you want to start? (y/N) y
TFTP EAP CA cert transfer starting.
Certificate installed.
Reboot the switch to use the new certificate.
Enter reset system to reboot the controller.
Step 10
After the controller reboots, enter show certificates local-auth to verify that the certificate is installed.
Step 11
Cisco Wireless LAN Controller Configuration Guide
9-18
The default values of 10 retries and a 6-second timeout should work correctly without any
adjustment. However, you can change these values. To do so, enter the maximum number of
times that the TFTP server attempts to download the software for the retries parameter and the
amount of time (in seconds) that the TFTP server attempts to download the software for the
timeout parameter.
The default value for the port parameter is 21.
Chapter 9
Managing Controller Software and Configurations
OL-17037-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4400 series

Table of Contents