Cisco 2100 Series Configuration Manual page 176

Configuring RFID Tag Tracking
Table 4-3
Partners
Product Name
Telemetry
Temperature
Pressure
Humidity
Status
Fuel
Quantity
Distance
Motion Detection
Number of Panic
Buttons
Tampering
Battery Information
Multiple-Frequency Tags
1. For chokepoint systems, note that the tag can work only with chokepoints coming from the same vendor.
Note Network Mobility Services Protocol (NMSP) runs on location appliance software release 3.0 or later. In
order for NMSP to function properly, the TCP port (16113) over which the controller and location
appliance communicate must be open (not blocked) on any firewall that exists between these two
devices. Refer to the Cisco Location Appliance Configuration Guide for additional information on
NMSP and RFID tags.
The Cisco-approved tags support these capabilities:
Information notifications—Enable you to view vendor-specific and emergency information.
•
Information polling—Enables you to monitor battery status and telemetry data. Many telemetry
•
data types provide support for sensory networks and a large range of applications for RFID tags.
Measurement notifications—Enable you to deploy chokepoints at strategic points within your
•
buildings or campuses. Whenever an RFID tag moves to within a defined proximity of a chokepoint,
the tag begins transmitting packets that advertise its location in relation to the chokepoint.
The number of tags supported varies depending on controller platform.
supported per controller.
Cisco Wireless LAN Controller Configuration Guide
4-80
Cisco Compatible Extensions for RFID Tags Summary
AeroScout
T2
X
X
1
X
1
X
Chapter 4 Configuring Controller SettingsWireless Device Access
WhereNet
T3 Wheretag IV
X
X
2 0
X X
X X
X X
Table 4-4
Pango (InnerWireless)
V3
X
X
1
X
X
lists the number of tags
OL-17037-01