Using The Cli To Configure Web Redirect - Cisco 2100 Series Configuration Manual

Configuring WLANs
Set any additional parameters for 802.1X or WPA+WPA2.
Step 5
Click the Layer 3 tab to open the WLANs > Edit (Security > Layer 3) page (see
Step 6
Figure 6-24 WLANs > Edit (Security > Layer 3) Page
Step 7 Choose None from the Layer 3 Security drop-down box.
Step 8 Check the Web Policy check box.
Choose one of the following options to enable conditional or splash page web redirect: Conditional Web
Step 9
Redirect or Splash Page Web Redirect. The default value is disabled for both parameters.
Step 10 If the user is to be redirected to a site external to the controller, choose the ACL that was configured on
your RADIUS server from the Preauthentication ACL drop-down list.
Click Apply to commit your changes.
Step 11
Step 12 Click Save Configuration to save your changes.

Using the CLI to Configure Web Redirect

Using the controller CLI, follow these steps to configure conditional or splash page web redirect.
To enable or disable conditional web redirect, enter this command:
Step 1
config wlan security cond-web-redir {enable | disable} wlan_id
To enable or disable splash page web redirect, enter this command:
Step 2
config wlan security splash-page-web-redir {enable | disable} wlan_id
To save your settings, enter this command:
Step 3
save config
Cisco Wireless LAN Controller Configuration Guide
6-52
Chapter 6 Configuring WLANsWireless Device Access
Figure 6-24).
OL-17037-01