Configuring And Viewing Location Settings; Installing The Location Appliance Certificate - Cisco 2100 Series Configuration Manual

Configuring and Viewing Location Settings

Configuring and Viewing Location Settings
This section provides instructions for configuring and viewing location settings from the controller CLI.
Access points in monitor mode should not be used for location purposes.
Note

Installing the Location Appliance Certificate

A self-signed certificate (SSC) is required on the location appliance. This certificate, which is comprised
of the location appliance MAC address and a 20-byte key hash, must be present on the controller.
Otherwise, the controller cannot authenticate the location appliance, and they can never establish a
connection. WCS usually pushes the certificate to the controller automatically, but you can install the
certificate on the controller using the controller CLI if necessary (for example, if the controller is not
connected to WCS or if an error or certificate mismatch occurs on WCS).
If an error occurs on WCS and prevents the location appliance certificate from being pushed to the
Note
controller, make sure that the time zone has been synchronized on the controller and the location
appliance before following this procedure. Follow the instructions in the
and Location Appliance" section on page 4-86
Follow these steps to install the location appliance certificate on the controller.
To obtain the key hash value of the location appliance certificate, enter this command:
Step 1
debug pm pki enable
Information similar to the following appears:
Thu Oct 11 08:52:26 2007: sshpmGetIssuerHandles: Calculate SHA1 hash on Public Key Data
Thu Oct 11 08:52:26 2007: sshpmGetIssuerHandles: Key Data
f70d0101
Thu Oct 11 08:52:26 2007: sshpmGetIssuerHandles: Key Data
02820101
Thu Oct 11 08:52:26 2007: sshpmGetIssuerHandles: Key Data
5bd20e5a
Thu Oct 11 08:52:26 2007: sshpmGetIssuerHandles: Key Data
09b723aa
Thu Oct 11 08:52:26 2007: sshpmGetIssuerHandles: Key Data
573f2c5e
Thu Oct 11 08:52:30 2007: sshpmGetIssuerHandles: Key Data
Thu Oct 11 08:52:30 2007: sshpmGetIssuerHandles: SSC Key Hash is
4869b32638c00ffca88abe9b1a8e0525b9344b8b
Cisco Wireless LAN Controller Configuration Guide
4-84
nmsp configures debugging of RFID NMSP messages, and
–
receive configures debugging of incoming RFID tag messages.
–
Chapter 4 Configuring Controller SettingsWireless Device Access
"Synchronizing the Controller
to do so.
30820122 300d0609 2a864886
01050003 82010f00 3082010a
009a98b5 d2b7c77b 036cdb87
894c66f4 df1cbcfb fe2fcf01
5c0917f1 ec1d5061 2d386351
b9020301 0001
OL-17037-01