Running The Configuration Wizard On The Cli - Cisco 2100 Series Configuration Manual

Using the Configuration Wizard

Running the Configuration Wizard on the CLI

When the controller boots at factory defaults, the bootup script runs the configuration wizard, which
prompts the installer for initial configuration settings. Follow these steps to enter settings using the
wizard on the CLI.
Note To configure the controller in the Catalyst 3750G Integrated Wireless LAN Controller Switch, Cisco
recommends that you use the GUI configuration wizard that launches from the 3750 Device Manager.
Refer to the Catalyst 3750G Integrated Wireless LAN Controller Switch Getting Started Guide for
instructions.
The available options appear in brackets after each configuration parameter. The default value appears
Note
in all uppercase letters.
If you enter an incorrect response, the controller provides you with an appropriate error message, such
Note
as "Invalid Response," and returns you to the wizard prompt.
Press the hyphen key if you ever need to return to the previous command line.
Note
Connect your computer to the controller using a DB-9 null-modem serial cable.
Step 1
Open a terminal emulator session using these settings:
Step 2
•
•
•
•
•
At the prompt, log into the CLI. The default username is admin and the default password is admin.
Step 3
Step 4 If necessary, enter reset system to reboot the unit and start the wizard.
Step 5 Enter the system name, which is the name you want to assign to the controller. You can enter up to 32
ASCII characters.
Enter the administrative username and password to be assigned to this controller. You can enter up to 24
Step 6
ASCII characters for each. The default administrative username and password are admin and admin,
respectively.
Enter the service-port interface IP configuration protocol: none or DHCP. If you do not want to use the
Step 7
service port or if you want to assign a static IP Address to the service port, enter none.
If you entered none in step 7 and need to enter a static IP address for the service port, enter the
Step 8
service-port interface IP address and netmask for the next two prompts.
Enable or disable link aggregation (LAG) by choosing yes or NO. Refer to
Step 9
information on LAG.
Enter the IP address of the management interface.
Step 10
Cisco Wireless LAN Controller Configuration Guide
4-4
9600 baud
8 data bits
1 stop bit
no parity
no hardware flow control
Chapter 4 Configuring Controller SettingsWireless Device Access
Chapter 3 for more
OL-17037-01