Clearing The Controller Configuration; Erasing The Controller Configuration; Resetting The Controller - Cisco 2100 Series Configuration Manual

Clearing the Controller Configuration

The controller does not support the uploading and downloading of port configuration CLI commands. If
Step 6
you want to configure the controller ports, enter these commands to do so now:
•
•
To save your changes, enter this command:
Step 7
save config
Clearing the Controller Configuration
Follow these steps to clear the active configuration in NVRAM.
Enter clear config and enter y at the confirmation prompt to confirm the action.
Step 1
Enter reset system. At the confirmation prompt, enter n to reboot without saving configuration changes.
Step 2
When the controller reboots, the configuration wizard starts automatically.
Follow the instructions in the
Step 3
initial configuration.

Erasing the Controller Configuration

Follow these steps to reset the controller configuration to default settings.
Enter reset system. At the confirmation prompt, enter y to save configuration changes to NVRAM. The
Step 1
controller reboots.
When you are prompted for a username, enter recover-config to restore the factory default
Step 2
configuration. The controller reboots and the configuration wizard starts automatically.
Follow the instructions in the
Step 3
initial configuration.

Resetting the Controller

You can reset the controller and view the reboot process on the CLI console using one of the following
two methods:
•
•
Cisco Wireless LAN Controller Configuration Guide
9-28
config port linktrap {port | all} {enable | disable}—Enables or disables the up and down link traps
for a specific controller port or for all ports.
config port adminmode {port | all} {enable | disable}—Enables or disables the administrative
mode for a specific controller port or for all ports.
"Using the Configuration Wizard" section on page 4-2
"Using the Configuration Wizard" section on page 4-2
Turn the controller off and then turn it back on.
On the CLI, enter reset system. At the confirmation prompt, enter y to save configuration changes
to NVRAM. The controller reboots.
Chapter 9 Managing Controller Software and Configurations
to complete the
to complete the
OL-17037-01