Cisco 2100 Series Configuration Manual page 720

System Messages
Table D-1
Error Message
ROGUE_AP_REMOVED
AP_MAX_ROGUE_COUNT_EXCEEDED
LINK_UP
LINK_DOWN
LINK_FAILURE
AUTHENTICATION_FAILURE
STP_NEWROOT
STP_TOPOLOGY_CHANGE
IPSEC_ESP_AUTH_FAILURE
IPSEC_ESP_REPLAY_FAILURE
IPSEC_ESP_POLICY_FAILURE
IPSEC_ESP_INVALID_SPI
IPSEC_OTHER_POLICY_FAILURE
IPSEC_IKE_NEG_FAILURE
IPSEC_SUITE_NEG_FAILURE
IPSEC_INVALID_COOKIE
RADIOS_EXCEEDED
SENSED_TEMPERATURE_HIGH
SENSED_TEMPERATURE_LOW
TEMPERATURE_SENSOR_FAILURE
TEMPERATURE_SENSOR_CLEAR
POE_CONTROLLER_FAILURE
MAX_ROGUE_COUNT_EXCEEDED
SWITCH_UP
SWITCH_DOWN
Cisco Wireless LAN Controller Configuration Guide
D-4
System Messages and Descriptions (continued)
Appendix D
Description
Detected rogue access point has timed out. The
unit might have shut down or moved out of the
coverage area.
The current number of active rogue access points
has exceeded system threshold.
Positive confirmation message.
Port may have a problem or is administratively
disabled.
Port may have a problem or is administratively
disabled.
Attempted security breech. Investigate.
Informational message.
Informational message.
Check WLAN IPSec configuration.
Check for attempt to spoof IP Address.
Check for IPSec configuration mismatch between
WLAN and client.
Informational message.
Check for IPSec configuration mismatch between
WLAN and client.
Check for IPSec IKE configuration mismatch
between WLAN and client.
Check for IPSec IKE configuration mismatch
between WLAN and client.
Informational message.
Maximum number of supported Cisco radios
exceeded. Check for controller failure in the same
Layer 2 network or add another controller.
Check fan, air conditioning and/or other cooling
arrangements.
Check room temperature and/or other reasons for
low temperature.
Replace temperature sensor ASAP.
Temperature sensor is operational.
Check ports — possible serious failure detected.
The current number of active rogue access points
has exceeded system threshold.
Controller is responding to SNMP polls.
Controller is not responding to SNMP polls, check
controller and SNMP settings.
Troubleshooting
OL-17037-01