Using The Cli To Retrieve Radio Core Dumps; Using The Gui To Upload Radio Core Dumps - Cisco 2100 Series Configuration Manual

Chapter 7 Controlling Lightweight Access Points

Using the CLI to Retrieve Radio Core Dumps

Using the controller CLI, follow these steps to retrieve the radio core dump file.
Step 1 To transfer the radio core dump file from the access point to the controller, enter this command:
config ap crash-file get-radio-core-dump slot Cisco_AP
For the slot parameter, enter the slot ID of the radio that crashed.
To verify that the file was downloaded to the controller, enter this command:
Step 2
show ap crash-file
Information similar to the following appears:
Local Core Files:
lrad_AP1130.rdump0 (156)
The number in parentheses indicates the size of the file. The size should be greater than zero if a core
dump file is available.

Using the GUI to Upload Radio Core Dumps

Using the controller GUI, follow these steps to upload the radio core dump file to a TFTP or FTP server.
Click Commands > Upload File to open the Upload File from Controller page (see
Step 1
Figure 7-7
From the File Type drop-down box, choose Radio Core Dump.
Step 2
From the Transfer Mode drop-down box, choose TFTP or FTP.
Step 3
In the IP Address field, enter the IP address of the TFTP or FTP server.
Step 4
In the File Path field, enter the directory path of the file.
Step 5
OL-17037-01
Upload File from Controller Page
Autonomous Access Points Converted to Lightweight Mode
Cisco Wireless LAN Controller Configuration Guide
Figure 7-7).
7-29