Starting The Test Instance - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-ftp-record trap-enable
Alarms are configured to be sent to the NM station after the FTP transmission succeeds.
When the FTP transmission succeeds at the first time, no alarm message is generated. From the
second time on, each time when the FTP transmission succeeds, an alarm message is generated.
----End

6.17.7 Starting the Test Instance

After you start a test instance, test results are field periodically.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run the nqa test-instance admin-name test-name command, enter the NQA test instance view.
Step 3 Run:
test-type { dhcp | dns | ftp | http | icmp | jitter | snmp | tcp | trace | udp }
The test type is configured.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
Issue 02 (2012-03-30)
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
195