Configuring Parameters For A Traceroute Test - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
No.
1
2
3
4

6.8.2 Configuring Parameters for a Traceroute Test

This part describes how to configure parameters for a traceroute test.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type trace
A traceroute test is created.
Step 4 Run:
destination-address ipv4 ip-address
The destination address of the traceroute test is configured.
Step 5 Run the following commands as required ( For detailed parameter configurations, see the chapter
Configuring Universal NQA Test Parameters
l To configure the maximum hops, run:
l To configure the initial TTL and maximum TTL values of a packet, run:
l To configure the source IP address, run:
l To configure the destination port number, run:
l To configure a NQA test packets to be sent without searching the routing table, run:
Issue 02 (2012-03-30)
Data
Administrator and name of an NQA test instance
Destination IP address
(Optional) VPN instance name, maximum hops, initial TTL and maximum TTL value
of the packet, and source IP address and destination port of the packet
Start and end modes of a test
tracert-hopfailtimes times
tracert-livetime first-ttl first-ttl max-ttl max-ttl
source-address ipv4 ip-address
destination-port port-number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
):
6 NQA Configuration
161