Huawei AR150/200 Series Configuration Manual page 191

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
l Run:
l Run:
l Run:
l Run:
l Run:
l Run:
l Run:
l Run:
l Run:
l Run:
Issue 02 (2012-03-30)
NOTE
This parameter cannot be configured for FTP and DNS test instances.
probe-failtimes times
The number of permitted maximum probe failures, that is, the threshold to trigger the trap
message, is set for the NQA test instance.
records history number
The maximum number of history records is set for the NQA test instance.
records result number
The maximum number of result records is set for the NQA test instance.
sendpacket passroute
The NQA test is configured to send packets without searching for the routing table.
NOTE
This parameter cannot be configured for DHCP, and DNS test instance.
set-df
Packet fragmentation is prohibited.
NOTE
This function can be configured only for the Trace test instances.
send-trap { all | { owd-ds | owd-sd | probefailure | rtd | testcomplete |
testfailure } * }
The condition for triggering the trap message is configured.
source-address ipv4 ip-address
The source IP address is set for the NQA test instance.
NOTE
This parameter cannot be configured for DHCP, and DNS test instances.
source-interface interface-type interface-number
The source interface is configured for the NQA test instance.
NOTE
The source interface can be configured for ICMP, and DHCP test instances.
source-port port-number
The source port number is set for the NQA test instance.
NOTE
This parameter is not applicable to the DNS test, ICMP test, DHCP test, and Trace test.
test-failtimes times
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
180