Configuring The Ftp Download Test Parameters - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
No.
6

6.4.2 Configuring the FTP Download Test Parameters

This part describes how to set parameters for the FTP download test.
Context
Do as follows on the NQA client (FTP client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type ftp
The test type is set to FTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters of the FTP Download
test ( For detailed parameter configurations, see the chapter
Parameters
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the FTP source port number, run the source-port port-number command.
l To configure the FTP destination port number, run the destination-port port-number
l To configure the NQA test packet to be sent without searching the routing table, run the
Step 6 Run:
ftp-operation get
The FTP operation type is set to Get.
By default, the FTP operation type is Get.
Step 7 Run:
ftp-username name
Issue 02 (2012-03-30)
Data
Start mode and end mode of the test
):
command.
sendpacket passroute command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
Configuring Universal NQA Test
149