Huawei AR150/200 Series Configuration Manual page 216

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Figure 6-5 Networking diagram of the FTP download test
Router A
FTP Client
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure IP addresses of Router A and Router B. (The detailed procedure is not mentioned
here.)
Step 2 Configure Router B as the FTP server.
<RouterB> system-view
[RouterB] ftp-server enable
[RouterB] aaa
[RouterB-aaa] local-user user1 password cipher hello
[RouterB-aaa] local-user user1 service-type ftp
[RouterB-aaa] local-user user1 ftp-directory flash:/
[RouterB-aaa] quit
Step 3 Create an NQA FTP test on Route A.
<RouterA> system-view
[RouterA] nqa test-instance admin ftp
[RouterA-nqa-admin-ftp] test-type ftp
[RouterA-nqa-admin-ftp] destination-address ipv4 10.1.1.2
[RouterA-nqa-admin-ftp] source-address ipv4 10.1.1.1
[RouterA-nqa-admin-ftp] ftp-operation get
[RouterA-nqa-admin-ftp] ftp-username user1
[RouterA-nqa-admin-ftp] ftp-password hello
[RouterA-nqa-admin-ftp] ftp-filename test.txt
Step 4 Start the test.
[RouterA-nqa-admin-ftp] start now
Issue 02 (2012-03-30)
Eth1/0/0
10.1.1.1/24 10.1.1.2/24
Configure Router A as the NQA client.
Create and perform an FTP download test on Router A to check whether Router A can set
up a connection with the FTP server and to obtain the time taken by Router A to download
the file from the FTP server.
IP address of the FTP server
Source IP address for the test
FTP user name and password
Operation file of the FTP test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Router B
Eth1/0/0
FTP Server
6 NQA Configuration
205