Table of Contents
Advertisement
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Applicable Environment
SNMP needs to be deployed in a network to allow the NM station to manage network devices.
If your network is a large scale with many devices and its security requirements are not strict or
its security is good (for example, a VPN network) but services on the network are so busy that
traffic congestion may occur, SNMPv2c can be deployed to ensure communication between the
NM station and managed devices.
Pre-configuration Tasks
Before configuring a device to communicate with an NM station by running SNMPv2c, complete
the following task:
l
Data Preparation
Before configuring a device to communicate with an NM station by running SNMPv2c, you
need the following data.
No.
1
2
3
1.3.2 Configuring Basic SNMPv2c Functions
After basic SNMP functions are configured, an NM station can perform basic operations such
as Get and Set operations on a managed device, and the managed device can send alarms to the
NM station.
Context
Steps 3, 4,
configurations, basic SNMP communication can be conducted between the NM station and
managed device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 (Optional) Run:
snmp-agent
The SNMP agent function is enabled.
Issue 02 (2012-03-30)
Configuring a routing protocol to ensure that the router and NM station are routable
Data
SNMP version, SNMP community name, address of the alarm destination host, and
administrator's contact information and location
(Optional) ACL number, IP address of the NM station, MIB object
(Optional) Name of the alarm-sending module, source address of trap messages,
queue length for trap messages, and lifetime of trap messages
5
, 6, and 7are mandatory for the configuration of basic SNMP functions. After the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
15
Advertisement
Table of Contents
