Establishing The Configuration Task; Configuring The Aggregation Function - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management

7.5.1 Establishing the Configuration Task

Before aggregating the original IPv4 unicast traffic statistics, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the data required for
the configuration. This will help you complete the configuration task quickly and accurately.
Applicable Environment
When the NetStream function is configured, a mode of collecting statistics about aggregation
traffic must be configured to classify statistics about packets according to certain rules.
Pre-configuration Tasks
Before configuring NetStream for aggregation traffic, complete the following tasks:
l
l
l
Data Preparation
To complete the configuration, you need the following data.
No.
1
2
3

7.5.2 Configuring the Aggregation Function

You can aggregate the original IPv4 unicast traffic statistics based on the as, as-tos, protocol-
port, protocol-port-tos, source-prefix, source-prefix-tos, destination-prefix, destination-prefix-
tos, prefix, or prefix-tos.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream aggregation { as | as-tos | destination-prefix | destination-prefix-
tos | prefix | prefix-tos | protocol-port | protocol-port-tos | source-prefix |
source-prefix-tos }
The NetStream aggregation view is displayed.
Issue 02 (2012-03-30)
Setting physical parameters on an interface
Setting the link-layer parameters of the interface
Setting an IP address for the interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
Data
Name and number of the interface on which
traffic statistics need to be collected
Version number of exported packets of the
NetStream traffic statistics
IP addresses and port numbers of the NSC
238