Huawei AR150/200 Series Configuration Manual page 268

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
collect statistics on the inbound and outbound traffic on an interface based on the destination IP
address aggregation and destination port aggregation. The statistics can be sent to the NSC.
Figure 7-4 Networking diagram for configuring Flexible NetStream
Network
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Set the IP addresses for the interfaces of Router A and Router B, as shown in
configuration procedure is not mentioned here.
Step 2 Specify the version of the exported packets.
# Set the version of the exported packets to V9.
<Huawei> system-view
[Huawei] sysname RouterB
[RouterB] ip netstream export version 9
Step 3 Set the source address, destination port number, and destination address for exporting packets.
# Set the destination address and destination port number for exporting packets.
[RouterB] ip netstream export host 10.2.1.2 6000
# Configure the source address for exporting packets.
Issue 02 (2012-03-30)
Eth1/0/0
User
10.1.1.1/24
Router A
Set IP addresses for the interfaces on Router A and Router B.
Specify the version of the exported packets.
Configure the source address, destination address, and destination port number for
exporting packets.
Configure the Flexible NetStream feature on Eth 1/0/0 of Router B.
IP address of each interface
Version of the exported packets
Address and port number of the NSC and the source address contained in the packets
Traffic statistics to be sent to the NSC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Eth2/0/0
NSC&NDA
10.2.1.1/24
10.2.1.2/24
Eth1/0/0
10.1.1.2/24
Router B
7 NetStream Configuration
ISP
Figure 7-4. The
257