Configuring Dhcp Test Parameters - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management

6.3.2 Configuring DHCP Test Parameters

This part describes how to set DHCP test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type dhcp
The test type is set to DHCP.
Step 4 Run:
source-interface interface-type interface-number
The source interface that sends the DHCP Request packet is configured.
The specified source interface can be an Ethernet interface connected with the DHCP server.
Step 5 (Optional) Run the following commands to configure other parameters for the DHCP test. For
detailed parameter configurations, see the chapter
Parameters
l To set the timeout period of the NQA test, run the timeout time command.
l To set the percentage of the failed NQA test, run the fail-percent percent command.
Step 6 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
Issue 02 (2012-03-30)
NOTE
The AR150/200 supports a router to function as a DHCP server. For detailed configurations, refer to the
chapter "DHCP Configuration" in the Huawei AR150&200 Series Enterprise Routers Configuration
Guide - IP Services.
NOTE
For the DHCP test, the time taken to wait for the response to the probe packet may reach 10 seconds. By
default, the timeout period is 15 seconds. You are recommended to set the timeout period longer than 10
seconds.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuring Universal NQA Test
6 NQA Configuration
146