Outputting The Statistics; Optional) Configuring The Inactive Aging Time - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
The default format is Version 5 with the AS option as peer-as. The output does not contain the
next hop BGP address.
----End

7.4.3 Outputting the Statistics

This part describes how to send the IPv4 multicast traffic statistics to the NMS for analysis.
Context
Do as follows on the router on which traffic statistics need to be collected.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream export source ip-address
The source address of the output statistics is configured.
Step 3 Run:
ip netstream export host ip-address port-nubmer
The destination address of the output statistics is configured.
You can configure at most two destination IP addresses respectively for the active and the
standby NSCs.
----End

7.4.4 (Optional) Configuring the Inactive Aging Time

The inactive time indicates the interval between the time the last packet arrives and the current
time. When the inactive time expires, the system ages the traffic immediately.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream timeout inactive inactive-interval
The inactive aging time of the original traffic is set.
By default, the inactive aging time of the original traffic is 30s.
----End
Issue 02 (2012-03-30)
NOTE
Version 5 does not support the output of the next hop of BGP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
235