Example For Configuring Lldp On The Device That Has Multiple Neighbors - Huawei AR150/200 Series Configuration Manual

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
l View the configurations on RouterB.
----End
Configuration Files
l
l
3.5.2 Example for Configuring LLDP on the Device That Has
Multiple Neighbors
After LLDP is configured on the network devices, the NMS can obtain the network topology.
The following example describes how to configure LLDP on the devices that have multiple
neighbors.
Networking Requirements
As shown in
network. The unknown network is not managed by the NMS, but can transparently transmit
LLDP packets. The NMS needs to obtain Layer 2 information about RouterA, RouterB, and
RouterC. By using the Layer 2 information, a network administrator can know the detailed
Issue 02 (2012-03-30)
Media policy Dscp
46
Power
Type :Unknown
PoE PSE power
source :Unknown
Port PSE
Priority :Unknown
Port Available power value:
2
Similar to information about RouterA.
Configuration file of RouterA
#
sysname RouterA
#
interface Ethernet0/0/8
ip address 10.10.10.1 255.255.255.0
#
lldp enable
#
snmp trap enable
#
lldp management-address
#
return
Configuration file of RouterB
#
sysname RouterB
#
interface Ethernet0/0/8
ip address 10.10.10.2 255.255.255.0
#
lldp enable
#
snmp trap enable
#
lldp management-address 10.10.10.2
#
return
Figure 3-8, RouterA, RouterB, and RouterC are connected through an unknown
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
:
10.10.10.1
3 LLDP Configuration
80