Huawei AR150/200 Series Configuration Manual page 213

Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the IP address of Router B.
Procedure
Step 1 Configure the IP address. (The detailed procedure is not mentioned here.)
Step 2 Enable the NQA client and create an NQA ICMP test.
<RouterA> system-view
[RouterA] nqa test-instance admin icmp
[RouterA-nqa-admin-icmp] test-type icmp
[RouterA-nqa-admin-icmp] destination-address ipv4 10.1.1.2
Step 3 Start the test immediately.
[RouterA-nqa-admin-icmp] start now
Step 4 View the test results.
[RouterA-nqa-admin-icmp] display nqa results test-instance admin icmp
NQA entry(admin, icmp) :testflag is inactive ,testtype is icmp
1 . Test 1 result
----End
Configuration Files
l
l
Issue 02 (2012-03-30)
Perform the NQA ICMP test to test whether the packet sent by Router A can reach Router
B.
Perform the NQA ICMP test to obtain the RTT of the packet.
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.1.1.2
Min/Max/Average Completion Time: 31/46/36
Sum/Square-Sum Completion Time: 108/4038
Last Good Probe Time: 2006-8-2 10:7:11.4
Lost packet ratio: 0 %
Configuration file of Router A
#
sysname RouterA
#
interface Ethernet1/0/0
ip address 10.1.1.1 255.255.255.0
#
nqa test-instance admin icmp
test-type icmp
destination-address ipv4 10.1.1.2
#
return
Configuration file of Router B
#
sysname RouterB
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
202